INA CSEA020-HLE bearings

Angular contact ball bearing, Thin section bearing CSEA, brass sheet metal cage

INA thin section bearing, angular contact ball bearing

Measurement system: Inch
Bore diameter: 50.800 mm
Outside diameter: 63.500 mm
Width: 6.350 mm
Cr: 3300 N
C0r: 3100 N
Limiting speed: 10500 r/min
Net weight: 50.0 g
Number of rows: 1
Contact angle deg: 30
Sealing: Without
Cage: Brass sheet metal
Bore type: Cylindrical
Outer diameter type: Cylindrical
Bearing material: Steel
Rolling material: Steel
Tolerance class: PL1
Lubricant in bearing: Without

In stock

Technical specification for INA CSEA020-HLE

INA CSEA020-HLE
Main Dimensions & Performance Data
Part Number	CSEA020-HLE
Logistical code	HLE
Sealing	Without	not sealed
Cage	YP	brass sheet metal
Tolerance class	PL1	Class PL1, Normal
Lubricant	Without	Bearing not greased
d	50.8 mm 2 in	Bore diameter
D	63.5 mm 2.5 in	Outside diameter
B	6.35 mm 0.25 in	Width
Cr	3300 N	Basic dynamic load rating, radial
C0r	3100 N	Basic static load rating, radial
n_G	10500 1/min	Limiting speed
m	≈ 50.0 g	Weight
Dimensions
r_min	0.6 mm	Minimum chamfer dimension
d₁	55.5 mm	Shoulder diameter inner ring
D₁	58.8 mm	Shoulder diameter on outer ring wide side face
D₂	60.2 mm	Shoulder diameter on outer ring small side face
α	30°	Shoulder diameter outer ring

INA CSEA020-HLE, Angular contact ball bearing, Thin section bearing CSEA, brass sheet metal cage. INA CSEA020-HLE have very small cross-sections relative to their diameters. This allows designs with smaller design envelope and lower mass, while achieving high rigidity and running accuracy.

INA CSEA020-HLE angular contact ball bearings (type E) can be filled with an increasednumber of balls and have a nominal contact angle of α = 30°. They cansupport considerably higher radial loads than deep groove ball bearings orfour point contact bearings and can support axial loads in one direction.

Comments